Hello All,
Im renovating our laundry room. Our new front loading units are alot lower and I would like to move this box down a few inches. The top the stand pipe is 23" above trap, I believe code is 18"min.
I have done minor plumbing(replaced sink shutoff valve,lines,faucet,etc). I have been reading alot about PEX.
Have a few questions:
1. Can I just cut the copper, install sharkbite fitting, run small piece of PEX to new PEX style Outlet box?
2. If #1 is ok, is there minimum PEX length from copper to new valve?
3. Just cut drain pipe,clean, then cement to new box?
Seem ok? Problems? Anything Im not thinking of?
Thanks!
Im renovating our laundry room. Our new front loading units are alot lower and I would like to move this box down a few inches. The top the stand pipe is 23" above trap, I believe code is 18"min.
I have done minor plumbing(replaced sink shutoff valve,lines,faucet,etc). I have been reading alot about PEX.
Have a few questions:
1. Can I just cut the copper, install sharkbite fitting, run small piece of PEX to new PEX style Outlet box?
2. If #1 is ok, is there minimum PEX length from copper to new valve?
3. Just cut drain pipe,clean, then cement to new box?
Seem ok? Problems? Anything Im not thinking of?
Thanks!
