DIY Home Improvement Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
How is the best way to cut wood paneling to mate up accurately with a curved ceiling.

When I say curved, this paneling is going inside a tear drop trailer, if that gives you an idea.
 

·
Too Short? Cut it Again!
Joined
·
9,634 Posts
You probably need a router and bit to be safe with thin paneling. You will have to remove a small groove, at regular intervals, so that you can bend the panels into place.
 

·
Retired Moderator
Joined
·
14,662 Posts
I built a teardrop camper a few years back, what type of wood paneling are you using? Are you a member of the TTT&T forum?

I used the T&G western cedar that Lowe's sells on our ceiling, it was easy to install, and looked great.
 

·
Too Short? Cut it Again!
Joined
·
9,634 Posts
Indeed T&G would make your ceiling install around the curvature a snap but I was assuming you had rigid sheets of paneling and that you have to make them work.
 
1 - 4 of 4 Posts
Top