DIY Home Improvement Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I am assembling a fixture that has six 4-pin CFLs. There will be a single on/off switch for the entire assembly. But I can't tell how to wire the lights.

The lamps use GX24Q-4 sockets. There are no markings on the fixtures and the supplier was no help. I even checked a couple of manufacturer's websites for [COLOR=blue !important]wiring diagramshttp://www.diychatroom.com/#, but found no help.[/COLOR]

Can anyone help me on this?
 

·
Super Moderator
Joined
·
22,733 Posts
The power does not get direct wired to the lamps. It goes to a ballast first. The ballast goes to the lamp socket and will have a drawing on it of how to connect it.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top