DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I started a project of putting in a hexagonal window. However, when we cut the hole in the sheet rock for the window, a nice discovery was made. Whoever originally wired/rewired the house, bored a hole through one of the studs and ran a wire through the middle of it. And it's right in the way of the window :thumbup:.

Anywho, I'm not sure where to proceed. I could just patch up the hole and forget about it, but that's not really my way. What is the best way to go about this without electrocuting myself? I have attached a picture of the offending wire.
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top