Whirlpool Thermal High Temp Fuse Keeps Blowing

653 Views 3 Replies 3 Participants Last post by gilliger, Feb 26, 2020

gilliger

Discussion Starter · Feb 25, 2020

I've got a Whirlpool WED9550WW1 (duet stackable dryer) that keeps blowing the high temp thermal fuse. The heating element is in good shape, not grounding out against the casing. Thermistor and other thermal fuse show continuity, along with the high temp thermostat. I checked the blower wheel and it seems to be operating properly. Oh, and yes, the air pathway is completely clear. Very short run to an outside wall.

Any ideas on what else it could be? I hate to mess with replacing the board until I'm 100% certain that's what it is.

Save

1 - 1 of 4 Posts

ront02769

· #2 · Feb 25, 2020

I’m sure that there are some appliances guys on the board..in the meantime., I’ve made pretty extensive use of the forums at partsdr.com . Yes, they are selling you the parts...but their pice is the same or less than the local appliance parts store sells them for even when shipping is included. And they are super at diagnosing your problem as most responses are from employees of the site who seem to k ow what they are talking about. Pasted below is a link to the one of the threads dealing with your issue.

http://forum.partsdr.com/showthread...l-Duet-Dryer-continually-blowing-thermal-fuse

Save

Reactions: 1

1 - 1 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month