DIY Home Improvement Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I have a Whirlpool LER7645EQ2 dryer. It's old, so I have some some maintenance and repairs. It's running well now, no problems. However, in the course of a repair I damaged a wire. It's one of the thinner wires, coming from the timer unit. It's part of a cluster of wires. It is orange. It meets up with 2 red wires which connect to the heater unit and the fuse on the heater.

What type of wire should I use to replace this wire? I see no gauge or temperature markings. It's currently working- the damage was readily handled with electrical tape, but I'll be replacing a couple of vent seals soon and I figure I might as well replace that while I'm in there.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top