DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered User
Joined
·
11,730 Posts
The ridge board is always full depth of cut rafters unless a low pitch(<3/12), then designed as beams. 1x boards "ok", check local code. IRC 802.3 The ridge board can be of any length, splice plates are not required here as it is not structural, only holding the rafters in opposite line.

Be safe, Gary
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top