DIY Home Improvement Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,013 Posts
Discussion Starter · #1 ·
I have a new water softener installed as part of my renovation project and there was no outlet existing for a water softener, which means I need to install one. The power supply is a small 12volt DC plug-in transformer with a 12-15ft cord on it, the cord would probably reach to the electrical panel along the wall and I could put the outlet next to the panel. My question is, since this will obviously not take hardly any power, it would be ridiculous to run it on its own circuit.

My question is, what other circuits can this be tied off of? The watersoftener is in the laundry/utility room where the main panel is located and pretty much everything mechanical/plumbing related.

The doorbell transformer is mounted to the bottom of the electrical panel and has been tied off a circuit for the upstairs hallway lights/entry light/exterior lights. Would this be ok to tap into for a transformer that should take less than prob 50 watts? Is there a better option?
 

·
Registered
Joined
·
1,013 Posts
Discussion Starter · #5 ·
I considered the laundry circuit, but neither one of the 2 outlets I am installing for the laundry room would be in a spot where the power pack would reach, so i'd have to install an additional outlet for the water softener anyway. Also, i'd prefer to run it with 14 guage on a 15 amp circuit. Would tieing it into a 15 amp lighting circuit for the basement bedroom/laundry/garage entry way/hallway lights be ok? I already have to do a complete re-wire on this circuit anyway....

As far as power consumtion, I believe the DC power adaptor is probably max of 1 amp at 12 volts.
 

·
Registered
Joined
·
1,013 Posts
Discussion Starter · #7 ·
Ok, I guess I am wiring it to the lighting circuit downstairs then. Outlet will be a GFCI since it will be in a partially un-finished utility/laundry room and near water. Thanks!
 
1 - 3 of 3 Posts
Top