DIY Home Improvement Forum banner

1 - 2 of 2 Posts

·
dIYHell
Joined
·
229 Posts
Discussion Starter #1
my plumbers installed a new washer box in my laundry room and I am trying to put my washers back in. I thought that the drain cap was just a knock out but it appears I have to cut it out? what size holes do I need to drill for this? any tips on getting this whole cut since I don't have an angle drill to get my hole saw in?

Scott
 

·
Registered
Joined
·
8 Posts
Scott: I don't know what type of box you have, but the white "Oatey's" that I use I just cut an x with an olfa knife then use plyers to hold each piece as I cut out the edge. Hope that helps. Rob.
 
1 - 2 of 2 Posts
Top