Wall switch to control outlet

728 Views 4 Replies 5 Participants Last post by Arrow3030, Jan 18, 2016

JustScrewIt

Discussion Starter · Jan 18, 2016

Hey folks, long time no see and all that good stuff. I'll get right to it. So I want to be able to turn a lamp via the switch on the wall that currently does nothing (actually, it's a double switch and one of them turns on the porch light. But the other one does nothing, as far as I can tell...) I plan to plug in the lamp to the outlet that is no more than 4 feet away from the switch. Is this a fairly straightforward task? I'm not completely inept, but not completely adept either, when it comes to electricimity... Just need a general overview and what supplies I would need. Much appreciated. its good to be back

Save

1 - 1 of 5 Posts

NickTheGreat

· #4 · Jan 18, 2016

joed said:
It is possible that the receptacle was at one time half switched. If someone replaced it and did not cut the tab between the hot screws the switch function would not work. It is possible that more than one receptacle was switched. If any one of them was replaced and the tab not cut, all of them would become unswitched.
The first thing to do is to check the wiring at the receptacles.

That's a good suggestion, the OP might get lucky and already have the wiring in place!

Save

1 - 1 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month