DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi all,
I would like to install two 8 watt undercabinet direct-wire lights to my kitchen. I would like to tie into the existing circuit for the light fixture over the sink, which is on a 15 amp circuit, separate from the 20 amp for the counter outlets.
The box for the existing sink light is not accessible from the attic, but I could feed wire up from underneath. Could I run a 14-2 wire tied in from the wires to the existing fixture, up to the attic to a new box, then split that off into two 14-2 wires going back down the walls to the new undercabinet lights?
Sorry if that is confusing. Thanks in advance for your help.

Jeff
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top