DIY Home Improvement Forum banner

Tubing bending question...

2409 Views 8 Replies 2 Participants Last post by  imposter h
I am trying to bend 1/4" stainless steel tubing 360 degrees into a coil. I can only seem to find tools that bend 180 degrees. I know that I have seen tight radius coils of stainless steel before. Is this something that can only be accomplished using thousands of dollars of tools and a factory or do any of you talented people have any tricks? Thanks in advance...
1 - 5 of 9 Posts
Frankly, I'll take anything up to 4" diameter...3" is ideal....
That sounds like it just might work...Thanks! It won't kink the tubing?
1 - 5 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top