DIY Home Improvement Forum banner

Trafficmaster Allure and Concete Sealer

5431 Views 1 Reply 2 Participants Last post by  yesitsconcrete
No, this is NOT a is Allure good or not post. I'm just moving forward.

Before I began installation, I did a moisture test on the slab. Bone dry as I expected. I had a gallon of leftover ProShield HPG (rubbery membrane) sealer so I decided to roll it on for an extra layer of protection.

As I've started to get a walkable area of Allure down (about 40%), I'm noticing a slight "sticky" sound from the floor. Seems like in areas where the slab isn't perfectly flat, and they're many, there's a slight give in the floor that makes the sound. The questions are:

1. As the ProShield cures, will it's tacky feel of it lessen?

2. Is this a permanent deal between the membrane and the slick underside of the Allure?

3. If I'm stuck with the with question 2, can I paint some primer of the sealer and fix it that way?

The company that makes the stuff doesn't have a web site or phone number on the bucket. Can't find them on the web via Google either.
Any insight would be much appreciated.
1 - 1 of 2 Posts
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.