DIY Home Improvement Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
What is the distance from my finished wall to the toilet ring? I think I read somewhere in the past that it was 12" to the center of the ring?

Also do I install this ring on top of my 1/4" cement board? Cement board in for the future tile.

Thank you
 

· Registered
Joined
·
2,784 Posts
If you mean "wax-ring", when you say toilet ring.
Don't install it on the sub-floor, the cement-board, tile!!!!
It goes against the "toilet-flange" on the plumbing and seals against the bottom of the toilet.
The more you raise the toilet; in relation to the floor -
the thicker wax-ring you're going to need!

rossfingal

Yeah - the distance from the wall to the center (where the bolts on the floor-flange are)
is usually 12 inches -
Remember -
If you're building out the walls (cement-board, tile, etc...)
That will decrease the distance!!
 

· Premium Member
Joined
·
13,078 Posts
Center of flange- no less then 12" to face of finished wall
Top of flange should not be below finished floor level- my opinion
 

· Registered
Joined
·
33 Posts
Discussion Starter · #4 ·
Oops sorry meant toilet flange. Ok no less then 12" from center of flange to finish wall. If I install it on top of the cement board and then tile around it would it be flush with the tile? If you like it higher than the finish floor should I built it up another 1/4" or whatever the tile thickness is so it higher then the tile (finish floor)?
 

· DIY Enthusiast
Joined
·
1,131 Posts
Oops sorry meant toilet flange. Ok no less then 12" from center of flange to finish wall. If I install it on top of the cement board and then tile around it would it be flush with the tile? If you like it higher than the finish floor should I built it up another 1/4" or whatever the tile thickness is so it higher then the tile (finish floor)?
Generally you want the flange slightly above the finished floor. Never below it.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top