Joined
·
737 Posts
I'm not much of a cabinet maker, but I can cut a 2x4! 
I have a small garage full of stuff - everything from fishing gear to lots of tools.
So, I decided to build an outfeed table for my table saw and add room for some storage. Then I got the bright idea of adding a shelf to hold frequently used tools like clamps, cordless screwdriver, etc. Nail guns are below in their storage cases. I had most of the materials, just needed a few 2x4's.
Like I said, I'm not a cabinet maker.
1) Basic 2x4 frame with base underneath for storage.
![]()
2) Shelf
![]()
3) Close up of shelf.
![]()
4) Closer look at shelf.
![]()
5) Finished table ready for action.
![]()
I have a small garage full of stuff - everything from fishing gear to lots of tools.
So, I decided to build an outfeed table for my table saw and add room for some storage. Then I got the bright idea of adding a shelf to hold frequently used tools like clamps, cordless screwdriver, etc. Nail guns are below in their storage cases. I had most of the materials, just needed a few 2x4's.
Like I said, I'm not a cabinet maker.
1) Basic 2x4 frame with base underneath for storage.
2) Shelf
3) Close up of shelf.
4) Closer look at shelf.
5) Finished table ready for action.
