DIY Home Improvement Forum banner
1 - 2 of 2 Posts

· Registered
2 Posts
Discussion Starter · #1 · (Edited)
i have sunstar tanning bed with a buck booster hooked up to it, i have 226 volts going to bed and it requires a max of 230. the problem is the bed won't run, a red lite is on, on the pcb board #241777-01, idt says power beside lite. bed tye zx32. when i got the bed (used) th buck booster was hooked up to 259 volts. any help will be appreciated i live in big rapids michigan. i have 240 comming into house
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.