DIY Home Improvement Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have a Frigidaire dishwasher model FDB636GFR2 that gets stuck mid-cycle. If I turn the knob less than 1/2" it'll complete the cycle no prob. Another site recommended I replace the timer. $130 later, the new timer gets stuck in the same place.
Any ideas?
Thanks
 

·
Super Moderator
Joined
·
21,623 Posts
What is it doing at that point of the cycle? It could be looking for a water level and the sensor is stuck.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
It is midway through the wash cycle. The knob stops in the vertical position and a 3-4 click turn gets it going again. It just keeps going if I don't turn it. Where/how do I check the sensor?
Thanks for the reply.
 
1 - 3 of 3 Posts
Top