DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
Hi! I have a countertop that extends beyond the wall by about 6 inches and is not cut perfectly straight. The first 20" is tucked into an alcove (and so can be concealed with silicone) but I have to put edging on the last 6 inches and to do this I need it flat... I'm sure the contractor thought he'd fix it when he comes back. Which he's probably never going to do.

My question (sorry - rant rant rant) - what is the best tool for making this flat (particle board with a laminate top - thanks ron!) without pulling it out as it's tucked in pretty good. There's a variance of about 3/8ths of an inch.

Thanks!!
 
1 - 1 of 1 Posts
Top