DIY Home Improvement Forum banner

still looking for that table saw

1359 Views 2 Replies 3 Participants Last post by  Just Bill
I came across a Delta Contractor saw Model#34-444 listed as excelent condition, this was on Craigslist @ $250.00 not sure how old this saw is, but looking for input on the price ,any info would help
1 - 3 of 3 Posts

· DIY Hack
Joined
·
1,306 Posts
That saw was a top of the line about 20- 30 years ago, and still considered a good saw today. $250 isn't a bad price, especially if its the cast iron version. I have seen them go for about half that price though....
 

· Registered
Joined
·
3,119 Posts
How old is it?? The older ones are better, new stuff is just not the same. That one is a belt drive. There was a model just under that which was direct drive amd very underpowered. Bought mine in '91, has had few problems. I wanted a cabinet saw, but could not justify the money. Contractors saw has done well for me.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top