Staining new cabinets.

1355 Views 3 Replies 2 Participants Last post by Bob Mariani, May 29, 2009

luweee

Discussion Starter · May 29, 2009

Okay all you pros, guide me through this please. I have some left over stain from my upstairs when I built my house 4 yrs ago. Am now installing a vanity in my basement bathroom. I am going to use the same stain for this project.

Can someone give me guidance. I know i have to

1. Stain
2. Seal it (urethane)
3. ???

I dont need to sand it, do I?? Can I seal it with a brush on type urethane?

Thanks people

Save

1 - 2 of 4 Posts

luweee

Discussion Starter · #3 · May 29, 2009

Thanks BOB

here are some specifics.

I had these cabinets made professionally.

They are oak.

They are already sanded and ready for stain.

My sanding question was.

after i apply urethane

do I need to sand. then apply again?

220 grit? (if sanding required)

Thanks

See less See more

Save

1 - 2 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month