DIY Home Improvement Forum banner

Staining lighter to darker cabinets

2205 Views 3 Replies 2 Participants Last post by  Godfueledbc
[B]Staining lighter to darker cabinets[/B]

Newbie here (both in forums and in home ownership)..thanks in advance for any help and patience!

So we just bought a house and I have "some" DIY skills and decided to jump head first into refinishing (sanding and restaining) the kitchen cabinets etc. We are going from a very light stain to a very dark stain.

My question is pertaining to how much I need to sand...I am willing to put in the work, but don't want to waste my time either if it's not needed. Basically I have sanded the doors and gotten much of the gloss finish off, but the light stain (kind of a white-wash color) is very stubborn to sand out. The problem is that when I have test-applied some stain, you can tell the difference in the areas where I was able to get down to the bare wood and the areas we couldn't get the stain off. It's not real glossy but you can definitely see a difference and it does have kind of a satin sheen where the old stain wasn't off...and the color looks the same with the obvious difference in the way it reflects. But.. that is before applying polyurethane.

I have also tried a chemical stripper to the doors, but it didn't really remove the stain either.

I am applying a matte poly over the stain afterward. I have already done the cabinet boxes and they look great. But, those doors are kicking my butt. So...assuming I get the poly (or whatever is sealing it) sanded off...will the new poly smooth everything out (as far as the gloss/matte) once I apply it at the end?? Or do I need to just get to the grind and put the work in to get everything down to the bare wood?

Thanks again in advance for any advice!
See less See more
1 - 3 of 4 Posts
I copied this thread over to Kitchen and Bath Remodeling...couldn't see where to delete it afterward...monitors are welcome to delete this one in the Paint section.
Bummer. I was afraid of that. Thanks.
1 - 3 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.