DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
955 Posts
By pass should divert the water away before entering the softener. If your system softens both cold and hot then you may have a leak at the bypass?? perhaps an o ring out of place...or stuck valve partially opened. Try opening and closing fully again.
If your system is plumbed to soften both then you will notice a soft taste in your drinking water.. but the salt taste would also seem to indicate the softener is now working....:thumbsup:
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top