DIY Home Improvement Forum banner
1 - 3 of 3 Posts

2 Posts
Discussion Starter · #1 ·
Hi All,

This is my first post here! I am looking for a little help on a small project that I am going to undertake. I am going to build a new duplex dog house with a slightly sloped roof (not quite flat).

My question is how to cut the top framing 2x4 's for the proper angle to give me a gradual slope for water to run off. I am thinking about a 1" slope from front to back.

The dimensions of the house are 71" (left to right) 39" (front to back) and 40" from top (highest point) to bottom.

I would appreciate your expertise! And Thank You!
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.