DIY Home Improvement Forum banner

Shower Pre-slope Mortar

2276 Views 3 Replies 4 Participants Last post by  ChiTownPro
I have put in a pre-slope mortar bed for a shower pan using the Pre-Pitch system and 4 to 1 Mortar bed mix. Before I install the liner there are a couple of places that aren't sloping to the drain almost level. What can I do to fix the problem? Can I mix up a little more mortar adjust the slope? I don't want to go further until it's right.
1 - 4 of 4 Posts
Yes--touch up the low spots right over the existing---a slightly damper mix might be needed.
  • Like
Reactions: 1
Time42play is that the Goof Proof system you are talking about? If so, how do you like it? Do you have any pictures to share?
Use a Kerdi pan and skip all the hassle and steps.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.