Shower Pan- Pre Slope

3614 Views 4 Replies 3 Participants Last post by Bud Cline, May 25, 2011

Paul8434

Discussion Starter · May 25, 2011

Hi all,

Have completed the pre slope on a shower pan and noticed a few areas where the concrete has sunk dis-proproportionately to other areas, creating some low spots on my slope from curb to drain.

Some of these low spots are around 1/16" deep over a 3-4" area.

should I

skim coat the pre slope to correct the sunken spots
remove pan and start over
do nothing and move to the liner stage and flood test?

Paul

See less See more

1 - 2 of 5 Posts

Bud Cline

· #3 · May 25, 2011

You are in great shape. The liner will conform to any small variance that exists and the second cement cast will see to it.

Keep going...excellent looking job from here. It's almost a shame to bury that one out of sight.

Bud Cline

· #5 · May 25, 2011

Don't forget to use a little sealer on top of that flange and under the pan liner.

1 - 2 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.