Securing OSB sub-floor to concrete

7294 Views 5 Replies 5 Participants Last post by pinwheel45, Jun 28, 2009

Rhat

Discussion Starter · Jun 27, 2009

I'm planning on putting down 1/2" OSB sub-floor directly on my concrete basement floor. My question is how to secure it? I have been told to simply use masonry nails with a baby-sledge, but have read a lot about using tapcon screws...

Can I use the masonry nails and be secure or should I go another route?

Save

1 - 1 of 6 Posts

Bud Cline

· #2 · Jun 27, 2009

Never gonna happen!

Why on earth would you want to do that to begin with?:laughing: You are getting some really bad advice from someone.:yes:

What do you have in mind after you install the OSB?

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.