[Ultrarunner2017]

Hi;
I need to replace the relay in my Kenmore canister vac, model # 116.20712008.
It looks pretty straight forward. I need to open the canister itself.
Looks to me that I need to remove 4 screws, 2 of which are under the cord rewind button.

I am not sure how to remove the cord rewind button. I would assume that since no screws are shown on the diagram for the button, it must pop out. But there is a spring under the button. Anyone have any advice on this?

Thanks

FW

 

[Robo_geek]

Hi;
I need to replace the relay in my Kenmore canister vac, model # 116.20712008.
It looks pretty straight forward. I need to open the canister itself.
Looks to me that I need to remove 4 screws, 2 of which are under the cord rewind button.

I am not sure how to remove the cord rewind button. I would assume that since no screws are shown on the diagram for the button, it must pop out. But there is a spring under the button. Anyone have any advice on this?

Thanks

FW

I have like six of these units, two working and four for parts. The cord-rewind button just pops off if you pry the right way.

http://www.fixya.com/support/t4535638-power_cord_caught_in_rewinder_sears