DIY Home Improvement Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
My decking is attached with screw nails and I need to replace a large number of the boards. There are approx. 27 screws in each board and to use a cats paw and hammer is almost impossible. The boards are not next to each other so I can't remove one or two and then pry them up. Is there a tool available to speed up this process. Basically when I get the cats paw under the nail head I require a gorrilla to pull them out to point where I can get a bar underneath to fully extract them.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #4 ·
I don't know how to cut a 5/4 x 6 plank with a Skill saw as described without cutting the adjacent boards as well. Like I said I am replacing boards at random. I guess I could drill holes and use a saber saw but I rather set the deck on fire. Has anyone ever used a pneumatic nail removal tool?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top