DIY Home Improvement Forum banner

saw stand feet

784 Views 8 Replies 5 Participants Last post by  de-nagorg
the saw sits on the usual 4 metal leg stand.
it is about 1.2 inch too low.
the stand does not have those screw in feet on the bottom.
what are the bolts/ feet actually called?
thanks all
1 - 2 of 9 Posts
do the legs have any holes in the bottoms? or can you drill a hole in the bottom of each leg?.if so you can just use a bolt with 2 nuts on each to give you whatever height you want, or if you want to make it portable get some caster wheels for it..
they sell feet with rubber or hard plastic on the bottom, take a look in the hardware isle at home depot..I believe they have a threaded bolt these
1 - 2 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.