DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
11 Posts
There are alot of factors when trying to jack a roof up. If you pull the walls back to level you have to hope that the rafter stay nailed to the wall plates. so fasten them with using rafter to the wall plate structural ties. i would use hurricaine ties. then use collars ties rafter to rafter to keep everything supported. chances are after all said in done you are not going to take the sag out. there are to many factors against you. most likely your just going to stop it from getting worse and make it safer.

good luck hope this helps.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top