DIY Home Improvement Forum banner

routering corner edges on square columns

1267 1
I would like to router part of the corners from porch square column. I have not installed the cedar wrap around boards but hope to get extra detail with some router work. Friend said use a 45 degree bit. I also want to leave square edge approx 5" at each end and gentle go into the edging look.

Do I free hand this or set up a jig? thanks for a post. m
1 - 2 of 2 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.