DIY Home Improvement Forum banner

Rheem furnance blows cold air

724 Views 2 Replies 3 Participants Last post by  yuri
I have a Rheem criterion gas furnace that blows cold air for 40 minutes after the heat cycle is off. I opened the panel and there is a yellow/amber light that is blinking. HVAC tech came replaced limit switch but issue still persists.

The furnace will start up, go through entire heat cycle without any problems. It reaches the correct thermostat setting temperature but blower fan does not stop 40+ minutes, blowing cold air, and the amber/light LED starts blinking fast again.

Thermostat setting is set to "auto". Please help with any advice!
1 - 1 of 3 Posts
Are you getting a call for the blower at the control board?
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.