When I add a few lights, I generally just use existing circuits.
Come from an existing switch (if it has a neutral) or a receptical.
Come from an existing switch (if it has a neutral) or a receptical.
Req: Help connecting circuit breaker and running wires
I'm new to DIY and would like some advice on running/installing a new 15 amp circuit and some ceiling lights. The purpose of the new circuit will be to power six 5" recessed lights, two 3" recessed lights, one chandelier, and one wall sconce in my living room and dinning room.
I can fish the wires and install the lights and switches, but what is your advice on connecting a new circuit? Should I attempt this, or is this a job that should be done by a professional?
Also, what are the rules for running new wires. I'm planning to just run the wire around the outside of my basement ceiling, attached to the basement framing (basement is finished with exception of the washer dryer area) and then up through the floorplate and between the studs into the dinning room area. Will this meet code or do I need to cut holes in the ceiling drywall and run the wires through the joists. Lastly, when I fish the wire up to the first floor, can the wires be loose beween the studs or will I need to cut a hole and staple the wires to a stud?
Any advice is GREATLY appreciated..... Thanks
I can fish the wires and install the lights and switches, but what is your advice on connecting a new circuit? Should I attempt this, or is this a job that should be done by a professional?
Also, what are the rules for running new wires. I'm planning to just run the wire around the outside of my basement ceiling, attached to the basement framing (basement is finished with exception of the washer dryer area) and then up through the floorplate and between the studs into the dinning room area. Will this meet code or do I need to cut holes in the ceiling drywall and run the wires through the joists. Lastly, when I fish the wire up to the first floor, can the wires be loose beween the studs or will I need to cut a hole and staple the wires to a stud?
Any advice is GREATLY appreciated..... Thanks
1 - 3 of 6 Posts
He is installing lights, not recepsDinning room needs to be on a 20 amp breaker
If the cable is behind drywall or above the joists it's fine.
It only has to be protected in conduit if it is "subject to physical damage". This means different things to diifferent people. I don't run exposed cable but many areas allow it.
It only has to be protected in conduit if it is "subject to physical damage". This means different things to diifferent people. I don't run exposed cable but many areas allow it.
1 - 3 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
DIY Home Improvement Forum
A forum community dedicated to Do it yourself-ers and home improvement enthusiasts. Come join the discussion about tools, projects, builds, styles, scales, reviews, accessories, classifieds, and more! Helping You to Do It Yourself!
Full Forum Listing
Explore Our Forums
Top Contributors this Month
View All
Nealtw
1050 Replies
chandler48
966 Replies
DoomsDave
502 Replies
Recommended Communities
