Replacing kitchen facet - nut stuck

1096 Views 4 Replies 4 Participants Last post by oh'mike, Nov 19, 2012

grand_canyon

Discussion Starter · Nov 18, 2012

I attempted to replace my facet when I was replacing the garbage disposal. Garbage disposal was easy not so for the kitchen facet. One side of the facet I could get a deep well socket which was easy. The other side has the sprayer hose with a large threaded hole and large nut. I tried spraying with WD40, I tried channel locks, I tried vise grips, I tried a crescent wrench nothing would budge it. I didn't want to totally trash it so I ended up just putting everything back together figuring I'll try later. Anyone have any suggestions?

Save

1 - 1 of 5 Posts

jaydevries

· #2 · Nov 18, 2012 (Edited)

i take a hole saw just bigger than tube and cut nut off

Save

1 - 1 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.