Replacing disposal...wiring regs

1412 Views 2 Replies 2 Participants Last post by twinrider1, Apr 28, 2011

twinrider1

Discussion Starter · Apr 28, 2011

Current install has a electrical box with a switch surface mounted under the sink. Then NM wire from the switch box to the disposal. That's how it was when I bought the house, and I've replace the disposal once, using the same setup. It lived a good life but is leaking and needs replaced.

New disposal has a plug. So I have the option to install an outlet or just removing the plug and using the existing NM wire.

Here's the issue. I'm reading a Black & Decker book and it says NM wire is not permitted in an open area where it can be damaged. Ok, but it makes me wonder.....if NM wire is a no-no, why is a cord with a plug on the end allowed? Does a cord offer more protection than the sheath on NM? I wouldn't think so.

Save

1 - 2 of 3 Posts

twinrider1

Discussion Starter · #3 · Apr 28, 2011 (Edited)

It's only exposed from the switch box to the disposal itself.
Thinking a new 4x4 electrical box, with both a switch and an outlet is the way to go. Though it sure is tempting to just wire it back like it was for the past 10+ years.

Save

1 - 2 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month