DIY Home Improvement Forum banner

Replace Mercury Vapor outdoor lights

1054 Views 3 Replies 3 Participants Last post by  mpoulton
I recently bought an older home in Texas that has mercury vapor landscape lighting. The lighting in the front yard doesn't work and trips the breaker, due to what appears to be a bad ballast on one of the lights.

I would like to replace these lights as they go out with LED bulbs and while I'm comfortable with electrical wiring indoors, I can't seem to get a clear answer on the outdoor wiring:

I haven't used my voltage tester on it yet, but I presume the wiring coming into the ballast is simply 120V and to convert a light from using mercury vapor bulbs to LED bulbs I would simply just re-wire/remove the ballast so the LED is running direct on the 120v line, just like an indoor light.
1 - 2 of 4 Posts
Thanks - yes, they are sealed in bullet fixtures as a few point up. These fixtures likely need to be replaced too. Great suggestion about integrated LED fixtures.
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.