DIY Home Improvement Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
99 Posts
Discussion Starter · #1 ·
Hi,
We're trying to take advantage of a great deal on a FLOOR MODEL deal on a fridge.

According to our measurements, after taking the doors and handles off, the fridge is still 1" too wide to fit sideways through one of our doorways.

We were thinking of taking the back panel off. If we did that would we gain an inch? Would we find things to "push in" so that it can squeeze through?

Thanks. A quick reply would be great as my wife is at home depot thinking what to do.

Andy
 

Attachments

·
Registered
Joined
·
3,009 Posts
The only way too know for certain would be too remove it at the store, beforehand, and see what it does for you, but based on any I recall you're not going to get another full inch. And then of course, even if you did make it, everything is exposed so if you got it cocked or whatever there's nothing to protect the guts. Sounds like one of those cases where it's so close but still too far.
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top