DIY Home Improvement Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I'm remodeling a bath on 3rd floor of townhouse. Would like to drop floor 1 1/2" in shower stall to avoid need for a curb. If I take the top plate off trusses (18") in shower area & sandwich the remainder between staggered 5/8" plywood (like you put on a 2 piece hip rafter) will that reinforce the trusses sufficiently?
If not, any suggestions?
 

·
Master General ReEngineer
Joined
·
10,200 Posts
I'm remodeling a bath on 3rd floor of townhouse. Would like to drop floor 1 1/2" in shower stall to avoid need for a curb. If I take the top plate off trusses (18") in shower area & sandwich the remainder between staggered 5/8" plywood (like you put on a 2 piece hip rafter) will that reinforce the trusses sufficiently?
If not, any suggestions?
Ayuh,... You already asked this question once,....

What's the matter, didn't like the answers or what....
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top