refrigerator

2972 Views 6 Replies 3 Participants Last post by bob22, Jun 6, 2011

tjbama

Discussion Starter · May 25, 2011

how do you replace a ribbon cable harness on a frigidaire refrigerator

1 - 3 of 7 Posts

Take it apart, replace it.
If your question is serious, it might help to provide a model number and what the ribbon cable connects to in the frig. I think Frigidaire has made more than one model in their long history.

Save

bob22

· #4 · Jun 1, 2011

I googled your model number and saw this diagram:
http://www.partselect.com/ModelFram...BJQ9D4&Position=4&mfg=Frigidaire&Type=&Mark=5
In panel 5 there are two "cables" shown. If you are replugging them in, make sure that the end is inserted correctly; usually the plug will have a slot or a ridge to guide correct orientation into the socket.
I assume you are plugging this cable in with the refrig unplugged? You may not have the ice dispenser paddle attached correctly and it may be sending a "dispense ice" signal to the system; check to see if it is correctly installed.
Is this the cable:
http://www.repairclinic.com/PartDetail/Wire/1196633?modelNumber=PLHS269ZDB9
Beyond that, I suggest trying:
http://appliantology.org/
if you don't get an answer here.

See less See more

Save

bob22

· #7 · Jun 6, 2011

You may not have the ice dispenser paddle attached correctly and it may be sending a "dispense ice" signal to the system; check to see if it is correctly installed.

Save

1 - 3 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month