DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Too Short? Cut it Again!
Joined
·
9,634 Posts
When you reapply the new stain, since you have a large area to cover, use the roller. I like to let the wood soak up the stain a little before continue.
And make that like a 3/4" nap or thicker roller cover. Have a brush handy to chase after your roller passes---immediately---to smooth out lap marks and make sure you get stain into the joints.

Spraying it is another possibility if there no danger of overspray to neighbors, your cars, etc. And you have to mask off carefully. Personally, I would roll it as suggested because you will get better coverage and penetration---IMO.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top