DIY Home Improvement Forum banner

Reduce height of concrete hearth

1747 Views 1 Reply 2 Participants Last post by  stadry
I'm replacing my tiled hearth with a marble slab. After removing the tile, the underlying concrete still sticks up above the surrounding finished wood flood by about 1/8". What's the best way to remove this 1/8" of concrete? An angle grinder? (Best, in this case, would mean minimal dust and work.) The marble slab will extend slightly onto the wood and I don't want to see a gap between the wood and the bottom of the marble. I don't want to add any trim to cover the gap. The concrete is about 6" thick.
1 - 2 of 2 Posts
minimal dust would be chipping gun, bushing tool, & decent vac ( not a apron/vest store special - rent a GOOD vac ) might need to finish w/4" grinder w/dust muzzle shroud depending on what skills you have
  • Like
Reactions: 1
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.