range hood specs?

2433 Views 2 Replies 3 Participants Last post by PLAIN O TX, Jun 12, 2009

homer12

Discussion Starter · Apr 18, 2009 (Edited)

I tried to replace my parents' range hood with one they purchased from Lowes. Turns out the vertical exhaust opening center point is 5" from the back of the unit while the existing was 6". Old one was a Kenmore and new one is Broan.

So the hole in the cabinet floor obviously doesn't match. And it isn't oversized enough to get the exhaust pipe in the collar. I know I can always take a jigsaw and open the hole in the cabinet up... but that would leave a big gap on one side. Also I am wondering why this dimension isn't standard and being that it isn't why can't I find the spec for that measurement on any range hood box or product info web page? Are all Broans 6" and Kenmores 5"?

Save

1 - 1 of 3 Posts

rondoharkin

· #2 · Jun 10, 2009

Re: Range Hood Specs

Hey Homer,

Usually the size of the ducting is relational to the output of the fan. Perhaps you purchased a unit that had a slightly lower CFM rating than the old one. I'm curious as to what model you purchased from Lowes and what model the old Kenmore was. You can find a copy of duct to CFM ratios here.

Save

1 - 1 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month