DIY Home Improvement Forum banner

Pool timer

1663 Views 3 Replies 3 Participants Last post by  pete1950
I have a t-104 Intermatic timer. It has A 1234 connection terminals with the load on the 2 & 4 terminals. The line are 1& 3 with 2 white wires from factory under the hubs. One thing which I am confused by is the old installation had a short white wire going from the A terminal to the grounding bar in the box. I put this back in the same way connected the load from the breaker on the 2 & 4 terminals and line on the 1-3 terminals on the timer with the white wires from timer. Turned back on power and motor works fine but timer does not run. Any ideas???
1 - 2 of 4 Posts

Why do I not need a neutral wire in the wiring of a timer???
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.