DIY Home Improvement Forum banner
1 - 1 of 1 Posts

·
Member
Joined
·
1,233 Posts
I would recommend red brass barbed fittings...then 2 clamps per barbed end...pulling opposite directions, with the threaded portion 180* opposite each other. To get the pipe on the fitting, heat the end slightly with a small soldering torch. The pipe will become very shiny when it's up to temperature. With the pipe still warm, install your clamps.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top