DIY Home Improvement Forum banner

pipe thickness

1605 Views 2 Replies 2 Participants Last post by  mmhendrie
I'm going to be installing a new shower mixer - which has an outlet for both a shower and one for a regular bath filler.

What are the typical width's of pipe that would feed the mixer, and then the pipe widths that would feed the shower head, and the bath faucette? I'm using copper if it makes a difference...

1 - 2 of 3 Posts
ok, thanks - you got it - it was the 1/2 vs 3/4 which i was wondering. I only have the hot/cold for the shower/tub (of which only one can be on at one given time) and one hot/cold for the sink. That's it - so i think 1/2" is where i'm at.

appreciate it!
1 - 2 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.