DIY Home Improvement Forum banner
1 - 1 of 1 Posts

26 Posts
Discussion Starter · #1 ·
My lawn mower has been surging. I did a pretty thorough job cleaning out the carb earlier this year. When I took out the pilot jet I stuck a fine wire down the hole and could see it in the cross hole so I assumed it was clear.

Now that it's surging I removed the pilot jet again and I can get a fine wire down the hole, but a slightly thicker one only goes in about 2mm and then stops. So does the hole have a shoulder inside of it, or does that sound like blockage (see pic below)? I soaked it for about 30 minutes in carb fluid but that didn't work.

Thanks in advance.

Steve S


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.