DIY Home Improvement Forum banner

PFTE on sharkbite threads?

589 Views 4 Replies 4 Participants Last post by  Ghostmaker
I just connected my angle SharkBite valves on the supplies under the sink. Getting ready to connect it to the lines on the faucet and I was just wondering if it is standard procedure to use PTFE on the threads before connecting? I can't find anything about it on Google.


See less See more
1 - 1 of 5 Posts
Tapered pipe threads is all i use PTFE on but on any other screwed plumbing fitting i apply a dab of plumber's grease to make ease of removal easier 20 years later when water minerals have attempted to make things difficult.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.