DIY Home Improvement Forum banner
1 - 1 of 1 Posts

410 Posts
Discussion Starter · #1 ·
Hello, I was putting up trim with a PC finish nailer and when I shot about the 4 nail in a spark came from where the nail went through the wood. Just wondering if this is normal. I have read that it is normal for framing nail guns, but don't know for finish nail guns.

The nail was 2 inch one.

I was putting up some cove molding up around my ceiling and thought two inches would be good to go through the molding, 1/2 drywall and ceiling into the furring. Hopefully I didn't shoot into a electrical wire:eek:
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.