DIY Home Improvement Forum banner
1 - 1 of 2 Posts

· Registered
1,543 Posts
Discussion Starter · #1 ·
So the picture below shows the wall where I have installed outlets in my detatched garage workshop with the new 100A panel I have installed shown on the left. I intend to build a workbench, I wanted to see if someone could clarify if I would require 30" or 36" or otherwise of depth for clearance to the panel? And since the panel is surface mounted, that distance is from the panel cover?


1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.