DIY Home Improvement Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I'm having vinyl siding put on my house and would like to remove the outside lights. Can anyone tell me what to do to the wires (clamp? ...) to make them neutral (other than shutting the circuit) while the work is being done?

Thank you.

Darlene
 

·
Banned
Joined
·
17,248 Posts
The installer isn't handling this?
Remove permantly ?
Clamp the wires - ?? What do you mean?
Usually you put a wire nut on the individual wires (when the breaker is off)

 

·
2 fingered typer
Joined
·
32 Posts
Shut of the breaker to the Outside Lights!

And do not work with an aluminum, ladder, or allow anyone else to do so! Put electrical "nuts" on the bare wires, do not twist wires together that were not already together, keep each wire separated and nutted. Tape over the breaker in the off position and note that it is shut off. When the siding is up return to normal.:) bill
 
1 - 4 of 4 Posts
Top